Page 12 Copyright © 2007 Proxim Wireless
Step 6: Assemble Mounting Hardware
Attach the mounting plate (A) using the provided screws and washers
(Torque 9 N∙m/75 in-lbs), such that the unit’s antenna will be vertically or
horizontally polarized when mounted.
Attach the extension arm (B) to mounting piece (A) with the screw, nut,
and washers provided, as shown below. The extension arm gives the unit
more possible tilt, letting you adjust for azimuth or elevation over a larger
angle.
Attach the mounting bracket (C) to extension arm (B) with the screw, nut,
and washers provided.
Tighten the assembly (Torque 15 N∙m/130 in-lbs).
The following gure shows the full assembly attached to the unit.
1.
2.
3.
4.
To Next Page
Loading...