Page 20 Copyright © 2007 Proxim Wireless
Step 13: Tighten the Cables
Apply two wraps of Teon tape around the threads of the unit’s RJ45 jack
(A) in a clockwise direction.
Make sure that the red rubber gasket is still seated in the sealing cap of the
sealing cap/lock nut assembly (B).
Slide the sealing cap/lock nut assembly (B) over the RJ45 jack (A) and
thread onto enclosure. Hand tighten rst, then use a pipe wrench or similar
tool to tighten one more quarter turn.
Caution!
Do not over-tighten!
Tighten the lock nut (C) (Torque 4 N.m/35 in-lbs).
Thread the sealing nut (D) onto the sealing cap/lock nut assembly (B) and
tighten (Torque 3 N.m/25 in-lbs).
Caution!
The lock nut (C) on the sealing cap/lock nut assembly (B) must
be fully tightened over the RJ45 connector before the sealing nut
(D) is fully tightened. Otherwise, the Ethernet cable may twist and
damage.
1.
2.
3.
4.
5.
To Next Page
Loading...
Need help?
General