All rights reserved Page 7
HARDWARE AND SOFTWARE INSTALLATION
Notes:
Be sure to read the Release Notes as they contains software version and
driver information that may not have been available when this document
was produced.
Equipment is to be used with, and powered by, the power injector provided
or by a power injector that meets these requirements:
UL-Listed/ITE (NWGQ)
Limited Power Source Output per UL/IEC 60950
CE-marked
Approved for Power-over-Ethernet
Rated output, 48 Vdc/0.42 A
Pinout follows 802.3af standard for mid-span devices
▪
▪
–
–
–
–
–
–
IMPORTANT!
Before installing this product, see Safety and Regulatory Compliance
Information on the product CD for important information.
IMPORTANT!
Before installing this product, see Safety and Regulatory Compliance
Information on the product CD for important information.
IMPORTANT!
All units must be installed by a suitably trained professional installation
technician or by a qualied installation service.
IMPORTANT!
All units must be installed by a suitably trained professional installation
technician or by a qualied installation service.
WARNING!
To ensure proper grounding, use the hole at the bottom point on the back
of each unit and the provided grounding screws to attach a ground wire of
at least 10 AWG stranded to each unit. Use proper wire grounding tech-
niques in accordance with local electric codes.
WARNING!
To ensure proper grounding, use the hole at the bottom point on the back
of each unit and the provided grounding screws to attach a ground wire of
at least 10 AWG stranded to each unit. Use proper wire grounding tech-
niques in accordance with local electric codes.
To Next Page
Loading...