PS Engineering
PAC45 Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-045-0000 Page 1-4 Rev. 7, May 2019
Audio Selector Specifications
Audio selector panel input impedance:
Switched Receiver Inputs:
11 (COM 1– COM 6, TEL, NAV 1, NAV 2, Marker, ADF)(Can be
relabled as desired)
7 (COM 1, COM 2, COM 3, COM 4, COM 5, COM 6 plus Tele-
phone) (Can be relabled as desired)
100 mW into 150 each side (left and right) headset, no clip-
ping <.5% THD typical
Speaker Output (-0002 & -0102 only)
Class 3, FCC ID QOQWT32AE
Up to 8 places (with individual IntelliVOX® circuits)
1 ( Stereo) plus Bluetooth
>-30 dB "Soft Mute" when Com or intercom active.
<1% THD @ 100 mW into 150
Mic Freq. Response, 3 dB:
Stereo Music Freq. Response, 3 dB:
1.6 EQUIPMENT SUPPLIED
The following units comprise the PAC45 System:
NVIS Compatible
Part Number
Single Panel-mounted System (HUB45 and CTL45P)
Remote-mounted Audio Hub for analog I/O and
processing
Panel-mounted Control Head for Flight Crew
Panel-mounted Control Head for Mission Personnel
.*The part numbers shown are for “Standard” bezel label nomenclature. Custom bezel nomen-
clature is available, using the custom configuration program at:http://www.ps-
engineering.com/PAC45_custom_legend.shtml
PAC45 Standard Installation Kit 250-945-0500 (37 & 50 Pin)
50 pin connector backshell
37 pin connector backshell
Lanpar Technolo-
gies, Inc.
Standard Density Female
Sockets
50 Pin Female Conn, Housing
37 Pin Female Kit Connector
w/Pins