63
CADDY WOOD/ELECTRIC
3.3.4.6 TECHNICAL DATA – ELECTRIC MODE
MODEL
OUTPUT
(CFM)
TEMP.
VAR.
(OF)
BTU/H
TOTAL
AMPERAGE
BREAKER
ALIMENT.
CALIBRE
VOLTAGE
1 PHASE
# OF
ÉLÉMENTS
15 KW
950
1300
50
36
51195 75 100 4 120/240 3 – 5 KW
18 KW
950
1300
60
44
61434 87 125 4 120/240
2 – 5 KW, 2 –
4 KW
20 KW
950
1300
67
49
68260 95 125 3 120/240 4 – 5 KW
25 KW
950
1300
1800
83
61
44
85325 115 150 2 120/240 5 – 5 KW
WOOD 15 120
3.3.5 OPERATING INSTRUCTIONS
3.3.5.1 FAN LIMIT CONTROL
The fan limit control settings may need to be adjusted depending on the
installation, but they are set at 110 °F (fan OFF) and 150 °F. (Fan ON) at the
factory and these settings will work best in most installations.
For continuous operation of the blower, use the switch located below the fan limit
control which controls the low speed either at the “ON” position or the “OFF”
position.
It is not recommended to let the blower run on continuous mode when heating
with wood since the wood furnace must reach a certain temperature before the
blower starts in order to operate efficiently.
3.3.6 TECHNICAL DATA
See Section 3.2.5, in Caddy wood only furnace.
To Next Page
Loading...
