PSG Caddy PF01010 - Electrical Connections; Installation of the Fan Limit Control; Servomotor Installation; Thermostat Installation

71
3.4.5 ELECTRICAL CONNECTIONS
The following instructions do not replace those of the local code.
Installation and verification of this appliance must be done by a qualified
service man.
All wiring from the service panel to the heating unit must comply with the
electrical code in force and all local regulations. It is recommended to feed the
furnace with its own electrical circuit of 15 amps at 120 volts with a breaker (see
wiring diagram).
All wiring between electrical components must be of sufficient length. It is very
important to keep away the wires from sources of intense heat.
3.4.5.1 INSTALLATION OF THE FAN LIMIT CONTROL
See Section 3.41, Necessary components for caddy wood/oil combination
furnace.
3.4.5.2 SERVOMOTOR INSTALLATION
See Section 3.2.3.2, in Caddy wood only furnace.
3.4.5.3 THERMOSTAT INSTALLATION
See Section 3.2.3.3, in Caddy wood only furnace.