89
6 PART E – REMPLACEMENT PARTS
Your PSG furnace was designed to burn clean requiring minimal cleaning. It is
good to visually check the furnace once a month for damaged or defective parts.
Any required repair should be made without delay using genuine PSG parts. An
exploded view and complete parts list is available for you on the PSG web site at
www.psg-distribution.com.
6.1 THE GLASS
• Check the glass regularly to detect any crack or damage. Replace damaged
glass immediately; do not use the furnace with a broken glass.
• The glass on your furnace is made of 5mm (3/16") thick transparent ceramic. If
the glass on your furnace has to be replaced, preferably use the original glass
sold by your PSG dealer or replace it with the same type of material.
• To replace the glass, remove the screws that hold the glass retainers to the
door frame and remove the retainers. Replace the damaged glass by the new
one and reinstall the retainers. The genuine glass sold by your dealer will have
a new gasket installed on it; make sure you install a new gasket if you do not
use the PSG replacement part.
• Never clean the glass with a product that could scratch it. Use a stove glass
cleaner available in most stores that sell wood stoves.
• Clean the glass only when it is cold.
6.2 THE DOOR GASKET
It is recommended to replace the gasket that seals the door once a year to insure
a good control of the combustion and the maximum safety and efficiency. To
replace the door gasket, remove the damaged gasket and scrap the dried glue
out of the groove where it layed. Apply a small amount of gasket glue or high
temperature silicone in the door groove. Lay the new gasket in the groove. Wait
at least 2 hours before relighting the stove.
To Next Page
Loading...
