Once you have reached the relevant menu, scroll through the parameters,
and enter the necessary information. To enter the information, use the UP
and DOWN keys to increment or decrement the digit, and the ENTER key
to shift the flashing digit to the next position, once you have completed
entering the value required pressing the ENTER button again will save the
value.
When you have finished, press CANCEL to go back to the previous level.
When you have reached the top level, then the IMP+
IMP+IMP+
IMP+ will ask for
confirmation before allowing you to go back into run mode. This is done by
pressing ENTER at the display prompt.
Parameter Defaults
Factory Defaults
Factory Defaults
When first installing the IMP+
IMP+IMP+
IMP+, or subsequently moving or using the unit on
a new application, before proceeding to program the unit for its intended
application it is recommended that you ensure that all parameters are at their
default values by completing a Factory Defaults P930, as described in
Chapter 5 Parameter Guide.
When you first switch the IMP+
IMP+IMP+
IMP+ on, it will be reading the distance from the
face of the transducer to the material surface. It will be indicating in metres,
as shown on the display. All relays are set OFF.
TIP
In some applications it is simplest to empty the
vessel, take a reading from the Imp for
distance and then setup the empty level to this
figure.
Once you are satisfied with the installation, and the IMP+
IMP+IMP+
IMP+ is reading what
you would expect in terms of distance from the face of the transducer to the
material level, then you can proceed with programming, for the intended
application. It is sensible to program all of the required parameters at the
same time. The system will be then set-up.
Note that the span is automatically calculated from the empty level, so the
empty level should be entered first.
To Next Page
Loading...
