Pylontech PowerCube-M1-C

21
2. Installation
Please check every installation step with <Annex 2: Installation and System Turn ON Progress List>
during the install.
3.1 Tools
The following tools are required to install the battery pack:
Wire Cutter
Crimping Modular Plier
Cable Ties
Screw Driver Set
Electric Screw Driver
Insulating Gloves
Adjustable Wrench
1500VDC Isolating nut drivers
2000VDC Multimeter
NOTE
Use properly insulated tools to prevent accidental electric shock or short circuits.
If insulated tools are not available, cover the entire exposed metal surfaces of the available
tools, except their tips, with electrical tape.