Enforcer Programming Manual
Page: 32
Program ARC/SMS: Fast Format Programming
1. Press or to scroll to 'PROGRAM ARC/SMS'. Press .
2. 'Program ARC/SMS Calls will be displayed. Press to program
the SMS numbers and event types.
3. 'ARC/SMS is' will be displayed. Use [ or ] to enable or disable
signalling and press .
4. 'ARC Details' will be displayed. Select the ARC account to be
programmed (1-4) and press .
5. 'Active' will be displayed. Use [ or ] to enable or disable the
ARC number and press .
6. 'Format' will be displayed. Enter [000] for FAST FORMAT and
press .
7. '1st ARC/SMS' will be displayed. Enter the primary ARC number
and press .
8. Second Number' will be displayed. Enter the backup number if
required and press .
9. 'ARC Account' will be displayed. Enter the account code that the
ARC has given and press .
10. 'Channels 1-8' will be displayed. Select the channels that will be
required to be signaled and press . Repeat for restores and
press .
11. 'Redials' will be displayed. Enter the number of redials required if
the number programmed is not answered and press .
12. 'Time Out' will be displayed. Enter the time and press .
13. 'Low Battery Report' will be displayed. Use [ or ] to enable or
disable the ARC number and press .
14. 'Test Calls' will be displayed. Use [ or ] to enable or disable
and press .
15. 'ARC Details' will be displayed and another number can be
programmed if required. Press to return to the sub-menu.
16. Press again and 'Program Digi Channels' will be displayed.
Press to program the digi channels for signaling Fast Format.
Refer to Appendix D, page 51 for the output types. Press to
return to the sub-menu.
4.23 Dial Out Menu
The Dial Out Menu can be used to dial to a remote PC (rather than the PC dialling the control panel).
The modem telephone numbers can be programmed in ‘SET UP DOWNLOADING’ – see page: 28. The
following actions can be performed: Connect to PC, Test Dial, Arm Service (The ARM software must
be used for this), Data from PC, Data to PC, Diagnostics and Commissions.
4.23.1 Select PC to dial
In the Enforcer 32-WE function 'Set Up Downloading', the PC number of where the UDL software
is installed is programmed. To dial this number, so the Enforcer 32-WE connects to the software,
use this function.
4.23.2 Select Operation
The following operations are available when dialing to the software:
[0] Connect to PC. [1] Test Dial. [2] ARM Service. [3] Data from PC. [4] Data to PC.
[5] Diagnostics [6] Commissioning.
PROGRAM
ARC/SMS?
Program ARC/SMS
Calls?
ARC/SMS is
Disabled [1]
ARC Details
[1]
Format [000]
Fast 4.8.1
1st ARC/SMSC
Second No.
ARC Account
Channels 1-8
.....6..
Redials
[03]
Program Digi
Channels?
To Next Page
Loading...
Need help?
General
