Enforcer Programming Manual
Page: 4
1. Introduction
The Enforcer 32-WE is a wireless alarm system that has been designed to enable easy installation and
minimal maintenance. The Enforcer 32-WE protects the property (domestic or commercial) with a
multitude of unique features:
• Two Way Wireless Protection
• Signal Strength Indicator (SSI)
• Instant Two Way Device Control
• Pyronix High Security Wireless Protocol Encryption
• Programmable Wireless Supervision Time
• Intelligent Wireless Jamming Detection
1.1 System Overview
Areas: 4 (1 single partition – 4 Levels Sets)
Wireless Inputs (max): 32
Wired Inputs (max): 34 (2 x inputs on I/O board (Inputs 33-34) and 4 x ZEMs
(Inputs 35-66)
Total Inputs: 66
Outputs (max): 38 (1 x output module and 3 x outputs on I/O board, 4 on each ZEM
if EURO-ZEM8+ or EURO-ZEM8+PSU are used, 1 on each RKP)
User / Manager Codes: 80 (Max 32 x wireless keyfobs)
Duress / Guard Codes: 10
Communications: PSTN (Digi-1200) or GSM (Digi-GSM) modem
Arm Devices (max): 4 (Including main keypad).
Logs: 750
Remote Arm and Soak Test:
Event Signalling to UDL:
Memory Type: EEPROM
Compliant to EN Grade
*
: 2
Environmental Class: II
1.2 Number of Additional Devices
Input Expanders (Wired): 4
Wireless Keyfobs: 32
Code Combinations: 4294967295 (fully encrypted rolling code)
Wireless Keyfob Variants 1
Wireless Bells: 2
Output Expanders: 1
Additional Keypads:
External Readers: 3
Internal Readers:
NOTE : All wireless learning is performed in the ‘WIRELESS DEVICE CONTROL’ menu, see page: 10 for
more details.
*Compliance labelling should be removed or adjusted if non-compliant configurations are used.
*Please note that technical functions for example fire, gas and flooding are not security graded as they
are outside the scope of EN50131-1 and EN50131-3.
To Next Page
Loading...
