QCT QuantaGrid D51PH-1ULH - Installing a Memory Module

INSTALLING HARDWARE INSTALLING A MEMORY MODULE
2-17
2. Press down on the two memory module slot levers (A). The memory module par-
tially ejects.
Figure 2-16. Removing a Memory Module
3. Lift out the memory module.
Installing a Memory Module
1. Remove the top cover. See Removing the Top Cover on page 2-11.
WARNING!
Memory modules remain hot after the system is powered down. Allow sufficient time for the
memory modules to cool before handling system components.
CAUTION!
HANDLE THE MEMORY MODULE BY THE EDGES AT ALL TIMES.
!
A
A
!