Qlogic SANsurfer FC HBA Manager

Troubleshooting
Tracing SANsurfer FC HBA Manager and Agent Activity (Debug)
7-16 SN0054651-00 G
S
Figure 7-2 Local.properties File
2. Edit the agent.properties file, which is located where SANsurfer is
installed. Change the following property:
(See Figure 7-3.)
node.agent.quiet.model.enable=0
Figure 7-3 Agent.properties File
3. Edit the SANsurfer.lax file, which is located where SANsurfer FC HBA
Manager is installed. Do one of the following:
NOTE:
Press and hold the CTRL key while starting SANsurfer FC HBA
Manager to display the messages in the console viewer. You can set
the displayed levels by updating the local.properties file or by
following these procedures.