Qlogic SANsurfer FC HBA Manager

Installing SANsurfer FC HBA Manager
Initial Installation
SN0054651-00 G 4-5
A
 For a Red Hat/SUSE Linux or Solaris SPARC/x86 system, follow these
steps:
a. Open a shell.
b. Change to the directory where you downloaded the SANsurfer
installer.
c. Unzip the package if necessary.
d. Type the following command at a command prompt, then press
ENTER:
sh ./standalone_sansurfer5.x.xbxx_linux_install.bin
The InstallAnywhere
®
window prepares to install SANsurfer and opens the
installation Introduction dialog box (Figure 4-2).
Figure 4-2 Install SANsurfer: Introduction
3. Click Next.