Qlogic SANsurfer FC HBA Manager

Installing SANsurfer FC HBA Manager
Uninstalling SANsurfer
4-32 SN0054651-00 G
S
Figure 4-27 Uninstall SANsurfer: Uninstall Complete
6. Click Done.
7. If any components were not successfully uninstalled, manually remove
them.
Some files and directories remain after uninstalling SANsurfer. You must
delete these components manually from the computer's hard disk where
SANsurfer was installed. The default locations are:
 For Windows:
Program Files\QLogic Corporation\SANsurfer
 For Red Hat/SUSE Linux and Solaris SPARC/x86:
/opt/QLogic_Corporation/SANsurfer
8. If you selected Add/Remove Programs in Step 1 to uninstall SANsurfer
HBA Manager from a Windows system, follow these steps:
a. To exit the Add/Remove Programs dialog box, click Cancel.
b. To exit the Control Panel, click Close.
9. If prompted, reboot the system.