Installing SANsurfer FC HBA Manager
Initial Installation
SN0054651-00 G 4-17
A
Figure 4-15 Install SANsurfer: Install Complete
14. To exit the installer, click Done.
Now you are ready to customize SANsurfer FC HBA Manager and set your
security parameters (see “Getting Started” on page 5-1).
Installation Instructions Using CLI
As an alternative, you can install the SANsurfer tool and its components using a
command line interface (CLI). This section lists the commands for Windows,
Linux, and Solaris stand-alone installation options.
NOTES:
To change the destination folder, add the -D parameter to the command
lines as follows:
-DUSER_INSTALL_DIR="d:\Apps\SANsurfer" ** you may
need to escape the \ here \\ **
To prevent installation of the desktop icon, enter the following command:
-DINSTALL_DESKTOP_ICON="false"
To Next Page
Loading...