Tip
If the computer is connected to the NAS through the management port, Qfinder Pro will also
display the the details of the second controller.
Controller Number IP Address
1
169.254.100.100
2
169.254.100.101
5. Configure the network settings.
a. On your Windows device, go to Control Panel > Network and Internet > Network and Sharing
Center .
b. Identify and click the network interface connected to the management port.
The Connection Status window opens.
c. Click Properties.
The Connection Properties window opens.
d. From the list of connections, select Internet Protocol Version 4 (TCP/IPv4).
e. Click Properties.
The Internet Protocol Version 4 (TCP/IPv4) Properties window opens.
f. Select Use the following IP address.
g. Specify an IP address and subnet mask.
Example:
• IP address: 169.254.1.10
• Subnet mask: 255.255.0.0
h. Click OK.
Tip
You can change the settings back to their original configuration after installing QES.
6. In Qfinder Pro, double-click an uninitialized controller.
The setup wizard opens.
7. Click Quick Setup.
The Quick Setup window opens.
8. Specify a NAS name and password.
Field Requirements
NAS name • Length: 1-14 characters
• Valid characters: A-Z, a-z, 0-9
• Valid special characters: Hypen (-)
• Not allowed: The last character is a hyphen (-)
Password • Length: 5-64 characters
• Valid characters: All ASCII characters
ES2486dc User Guide
Installation and Configuration 44
To Next Page
Loading...
