Hot-Swapping Redundant Power Supplies
NAS devices with redundant power supply units (PSUs) support hot-swapping.
Warning
The NAS may have one or more power supply unit (PSU) cords. To avoid serious injuries,
a trained service technician must disconnect all PSU cords before installing or replacing
system components.
1. Power off the NAS.
2. Disconnect the power cord from the electrical outlet and the PSU that you are replacing.
3. Firmly press the latch toward the handle and then pull the PSU out.
4. Insert the new PSU.
TS-h1283XU-RP User Guide
Installation and Configuration 24
To Next Page
Loading...
Need help?
General
