QOLSYS Panel 2+ - AUTO LEARN SENSOR PROCEDURE

SECURITY SENSORS
1. Select “Auto Learn Sensor”
2. Open/Close or Tamper a sensor to enroll. For PowerG contacts, hold the “enroll” button until
the yellow LED flashes.
3. Panel will chime and display the sensor’s DL code. Select OK to confirm
4. Configure Partition Name, Sensor Type, Sensor Group, Sensor Name, Chime Type and Voice
Prompts with the smart filtering drop down lists.
5. Select “Add New” to complete and move to the next sensor.
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 54 173
AUTO LEARN SENSOR