QOLSYS Panel 2+ - SECURITY AND ARMING SETTINGS

PROGRAMMING
SECURITY AND ARMING
FIND IT
SECURITY AND
ARMING
Swipe down
for access
INSTALLATION
SETTINGS
ADVANCED SETTINGS
ENTER CODE (1111, 2222)
Setting
Default
Description
Dealer Code*
2222
Code to access all options
Installer Code
1111
Code to access installer options only
Swinger Shutdown
Enabled
Determines whether the panel allows the same sensor to trip the
alarm more than once (enabled), or not (disabled)
Swinger Shutdown
Count
1
Determines the number of times the same sensor is allowed to trip the
alarm during the same arming period (1-6). Swinger Shutdown must
be enabled in order for this setting to work. NOTE: for EN Grade 2 it shall be set
to 3.
Panel Tamper
Enabled
This setting enables or disables the Panel Tamper switch on the back of
the panel. NOTE: for EN Grade 2 this setting shall be Enabled.
Screen Lock
Disabled
When enabled, a screen lock page will appear. Screen lock restricts
access to the panel based on valid user codes. NOTE: This setting is required
and is automatically enabled when Partitions are enabled. It must be Enabled for EN Grade 2
Security and Arming
Change arming settings, entry and exit delays, enable Duress Authentication
and more.
* Additional options available
only through the Dealer Code.
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 39 173