QOLSYS Panel 2+ - SIREN AND ALARMS CONFIGURATION

Setting
Default
Description
Panel Sirens
All Sirens
On
All Sirens Off: This will disable the siren for all alarm types
including any paired or hardwired external sirens. After 30 mins
the fire siren will be re enabled.
All Sirens On: This is the default setting which enables the siren
for all alarms
Installer/Test Mode: This disables the siren for all alarm types
including any paired or hardwired external sirens for 30 mins then
all sirens are re-enabled
Siren Annunciation
Disabled
Panel siren pauses periodically to announce which locations have
triggered the alarm.
Fire Verification
Disabled
When enabled, panel requires two fire events from smoke
detector (one detector twice or two detectors once each)
Severe Weather Siren
Warning
Enabled
When enabled, siren will sound when the panel receives a severe
weather alert. When disabled, panel will use severe weather
chime
PROGRAMMING
SIREN AND ALARMS
FIND IT
SIREN AND ALARMS
Swipe down
for access
INSTALLATION
SETTINGS
ADVANCED SETTINGS
ENTER CODE (1111, 2222)
Siren and Alarms
Change siren and alarm settings for certain types of alarm events.