20
DS-1200 G4i Operator Manual Issue 4 - Nov 2020
Collator Fine Tuning
On the Run screen graphic, press anywhere on the Collator icon.
Note that each heading expands.
You can change:
• Feed control mode: Turn o to disable folder.
• Doubles detect: Turn o if thick or dark envelopes give false readings.
• Address adjust: Adjustment up or down of address position in envelope
window.
• Load to Reader (reading units only): this will feed one document into
position under the reader. Press Reader On to test the reader, Reader O to
end the test. Remove the document and replace on feed hopper.
• Separator wear: Adjust separator gap only if needed (1 clock = 0.015mm).
This changes the gap on the unit and applies to all jobs: see also Gap Adjust
below.
• Documents: Changes to the insert depth & width.
• Gap Adjust: Adjusts the separator gap for this document only (1 clock =
0.015mm). Note that this is relative to Separator Wear, and adds to or
subtracts from that setting. The setting is saved with this document and
remains for future uses.
To Next Page
Loading...
