31
DS-1200 G4i Operator Manual Issue 4 - Nov 2020
3 If required, press Settings to dene document usage and adjustments.
Settings shown will vary depending upon whether a feeder,
folder or collator is tted, and whether a reading unit.
Settings for a Feeder, Folder or Collator Unit are described below:
Feed control mode:
Feed always (default)
Mark Selects - feeds document when select mark is read.
Reading + Fixed Multiple (Feed Always) - reads label, then always feeds
multiple set in Form Count (only available on reading units).
Reading + Fixed Multiple (Mark Selects) - reads label, then feeds multiple
set in Form Count when mark in prime document is read (only available on
reading units).
NOTE: Mark Reading (see below) must be On for any reading mode.
Form count:
Set quantity - see Feed Control Mode above.
Fold type:
Select fold type required only if you have a requirement to deviate from
default.
Mark Reading:
Set mode of reading required. This will vary depending upon reader type tted
(O is the only available option for non-reading feeder).
To Next Page
Loading...
