Maintenance
quantum
MASCHINEN - GERMANY
© 2007
GB
Page 34 Drilling machine B 13 / B14 / B16 / B20 / B25 / B32 Version 1.2.5 18 / 01 / 2008
5 Maintenance
In this chapter you will find important information about
• inspection,
• maintenance,
• repair of the drilling machine.
The diagram below shows which of these headings each task falls under.
Illustr. 5-1: Maintenance –Definition according to DIN 31051
ATTENTION!
Properly-performed regular maintenance is an essential prerequistite for
• safe operation,
• fault-free operation,
• long service life of the drilling machine and
• the quality of the products you manufacture.
Installations and equipment from other manufactures must also be in optimum condition.
ENVIRONMENTAL PROTECTION
During work on the spindle nose and the apron, make sure that
• collector vessels are used, with sufficient capacity for the amount of liquid to be col-
lected,
• liquid and oils are not spilt on the ground.
Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current legal requirements on the environment.
Cleaning up spillages
Do not re-introduce liquids spilt outside the system during repair or as a result of leakage from
the reserve tank: collect them in a collecting vessel to be disposed of.
Disposal
Never dump oil or other pollutant substances in water inlets, rivers or channels.
Maintenance
Inspection Maintenance
Repair
Measuring Rough cleaning Mending
Testing Fine cleaning Replacing
Conserving
Lubricating
Completing
Replacing
Readjusting
Adjusting
To Next Page
Loading...
Need help?
General
