Appendix
quantum
MASCHINEN - GERMANY
© 2007
GB
Page 56 Drilling machine B 13 / B14 / B16 / B20 / B25 / B32 Version 1.2.5 18 / 01 / 2008
8 Appendix
8.1 Copyright
© 2007
This documentation is copyright. All derived rights are also reserved, especially those of transla-
tion, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means
and recording in data processing systems, neither partial nor total.
The company reserves the right to make technical alternations without prior notice.
8.2 Terminology/Glossary
Term Explanation
drill drift tool to release the bit or the drill chuck from the drill
spindle
drill chuck drill holding fixture
drilling head upper part of the drilling machine
drill sleeve fixed hollow shaft which runs in the drill spindle
drill spindle shaft driven by the engine
drilling machine table support face, clamping surface
morse taper cone of the drill or of the drill chuck
sleeve lever manual control for the drill feed
quick action drill chuck drill holding fixture to be clamped manually
workpiece part to be drilled, part to be machined
tool bit, countersink, etc.
locking pin pin to hold the drill sleeve at a certain height in order
to disassemble the drill chuck or the tool
To Next Page
Loading...
Need help?
General
