Connecting to the LTE IoT 2 click
Connect to the LTE IoT 2 click over USB, or using the MIKROE click serial interface.
If you are testing a single unit, we recommend that you use a terminal emulator to execute the
AT commands, for example PuTTY or Tera Term.
Serial port settings
Change the port settings using Device Manager, and ensure you also adjust the serial port settings in
the terminal emulator.
Serial port setting Default value
Baud rate 115200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
Send the following AT command to enable MQTT: AT+ETMSTATE=startmqtt
If the configuration file [operation] <mode> is set to mqtt, then ETM automatically starts
MQTT after power up. If the <mode> is not set, after each reboot you must send
AT+ETMSTATE=startmqtt again.
Send the following AT command to enable MQTT: AT+ETMSTATE=startmqtt
If the configuration file [operation] <mode> is set to mqtt, then ETM automatically starts MQTT after
power up. If the <mode> is not set, after each reboot you must send AT+ETMSTATE=startmqtt again.
3
Eseye-enabled Quectel BG96 module Developer Guide v1.8
Connecting to the LTE IoT 2 click
To Next Page
Loading...
