Quectel BG96 - BG96 Antenna Interfaces; Main Antenna Interface, Frequencies, and RF Layout

+ETM Unsolicited Response Codes (URCs)
The Eseye Telemetry Module adds the following Eseye URCs to the modem. All ETM URCs are prefixed
+ETM:.
You will continue to observe other URCs from the Quectel BG96 module.
For information about all other URCs, see the relevant Quectel documentation. For more
information, contact Quectel Wireless Solutions or their channel partner.
URC Description
+ETM:EMQRDY
ETM has entered MQTT mode and is ready to accept any AT+EMQ...
commands. Prior to this, only AT+ETM... commands are accepted.
+ETM:IDLE
The modem has started up and is ready for commands.
+ETM:REBOOTING
The modem will shortly restart. Wait for +ETM:IDLE before sending
commands. Configure automatic rebooting using update_
autoreboot in the configuration file. For more information, see Using
the Quectel BG96 module configuration file on page62.
+ETM:REBOOT REQUIRED
The modem has received an update and needs to restart. While
operation can continue as normal, the host should issue AT+ETMRESET
at a convenient time. This restarts the device and applies the update.
Configure automatic rebooting using update_autoreboot in the
configuration file. For more information, see Using the Quectel BG96
module configuration file on page62.
+ETMSTATE:<StateID>
where <StateID> is the
current connectivity state
of the Quectel BG96
module.
Enable this response using the AT+ETMSTATE write command. For
more information, see ETMSTATE – check current state on page41.
+ETM:SYSSTART
Indicates that the Eseye Telemetry Module application has started.
43
Eseye-enabled Quectel BG96 module Developer Guide v1.8
ETM Management AT commands