Quectel BG96 - General at Commands for the Quectel BG96 Module

General AT Commands for the Quectel
BG96 module
You can directly access the cloud and manage the Eseye-enabled Quectel BG96 module using AT
commands.
You can find a full set of the Quectel BG96 module AT commands here:
BG96 AT Commands Manual PDF
Use a terminal emulator to send test, read and write AT commands to the Quectel BG96 module. For
terminal emulator configuration information, see Connecting to the LTE IoT 2 click on page3.
Before you begin
Before you use any Eseye-enabled AT commands on the modem, ensure that it is ready to receive
AT commands.
To test that the modem is ready to receive ATcommands:
1. Using a terminal emulator that is connected to your modem, type:
at<return>
The terminal emulator will return any of the following:
OK – the modem is connected and ready to communicate with the host
ERROR– the modem cannot communicate with the host. Contact the modem supplier.
Nothing – ensure you have set the correct baud rate in your terminal emulator. For more
information, see Connecting to the LTE IoT 2 click on page3.
2. Type: at+etminfo=version<return>
The terminal emulator will return either of the following:
•
Eseye Telemetry Module V<version>, where <version> is the current
software version – the modem is ready to receive ATcommands. Verify that the
version number is Eseye Telemetry Module V0.99_ma or higher.
•
ERROR – the modem is not ready to receive ATcommands. The ETM software has not
yet initialised. Try again in 5 seconds.
31 Eseye-enabled Quectel BG96 module Developer Guide v1.8
General AT Commands for the Quectel BG96 module