257
Steam delivery
1. Wait until the heating light (q) switches off and make sure that the
pressure indicated on the boiler gauge (h) is more than 0.8 Bar.
2. Open the steam valve (d) for a few seconds and discharge a little steam into
the drip tray (e) then immerse the steam wand in the liquid to be heated and
open the tap, when the required temperature is reached, close the tap
After the brew has been heated, always discharge a little steam
from the wand to clean the spray holes
Hot water delivery
1. Place the container to collect the water under the hot water wand (g).
2. Open the water tap (f) to deliver the hot water.
3. When the required level is reached close the water tap.
Boiler temperature adjustment
For model 0980 - ANDREJA PID the boiler temperature management is done
through the TERMOPID: refer to the chapter "TERMOPID OPERATION AND
PROGRAMMING" under "SINGLE TEMPERATURE TERMOPID".
Coffee pressure adjustment valve
The machine is delivered with the coffee pressure adjustment valve (l) set at 10
Bar. The end user can adjust the valve (l) to increase or decrease the pressure
1.
Release the filter holder from the group.
2.
Remove the filter from the filter-holder.
3.
Insert the blind filter in the filter-holder.
4.
Attach the filter holder to the coffee brew group.
5.
Start the coffee brew group delivery to obtain the maximum pressure in the
circuit, shown on the pump pressure gauge (i).
6.
Remove the cup warmer plate to have access to the adjustment screw (l).
7. Act on the valve adjustment screw, turning it clockwise to increase the
pressure and anticlockwise to decrease the pressure in the circuit.
To Next Page
Loading...
Need help?
General
