Quicksilver 805PH - Page 63

Quicksilver 805PH — Electrical Systems
51
Turning O and Disconnecng Shore Power
To disconnect shore power:
On the Boat
1. Make sure that the all of the breakers on the AC Distribuon Panel are OFF
On the Dock
1. Turn OFF the dock breaker.
2. Disconnect the dockside end of the power cord.
On the Boat
1. Disconnect the power cord from the shore power receptacle.
2. Clean the power cord, spray the plugs with a moisture repellent and store the cord in a dry
locaon on the boat.
You must keep the shore power cord and plug ends clean and dry. This is especially necessary if your
boat is used in salt water. Always clean and spray your cord ends with moisture repellent before using
and before storing the cord.
Do not allow shore power cable end to hang in water. An
electrical eld can result which can cause injury or death to
nearby swimmers.
To minimize shock and re hazards turn o cra’s shore
power connecon switch before connecng or
disconnecng shore power cable, connect shore power
cable to cra’s inlet before connecng to shore power
source, disconnect shore power cable at shore power rst,
and close shore power inlet cover ghtly.
AC Panel
Reverse polarity indicator
Main breaker switch — 16 Amp
Main test buon
Baery charger breaker switch — 10 Amp
Outlet breaker switch — 7 Amp