3. To scroll quickly through the list, press and hold or .
4. To exit the Caller ID list while the phone is in standby:
HANDSET: Press .
BASE: Press /EXIT.
If you are looking up an entry during a call:
HANDSET: Press /FLASH.
BASE: Press /EXIT.
During a call, pressing
on the handset or on the base to
exit the Caller ID list will disconnect the call immediately.
The number of calls from the same Caller ID will
appear next to the time to indicate that this is an
unread message. If you received 10 or more calls
from the same Caller ID, * appears. Once you
review the new message, the number or * will
disappear.
Making a Call from a Caller ID Record
1. When the phone is in standby, press .
2. Use
, , or a number key (0, 2 – 9) to nd the Caller ID
record you want to dial.
3. To add (or delete) a “1” at the beginning of the displayed
phone number, press /TONE. To add (or remove) the stored
area code, press #.
4.
To dial the number:
HANDSET: Press /FLASH or SPEAKER.
BASE:
Press or pick up the base corded handset.
The phone will automatically select a free line.
OR
To dial the number selecting a particular line:
HANDSET: Press the LINE1 or LINE2 soft key.
BASE: Press LINE1 or LINE2.
To Next Page
Loading...
