42
Before scanning a trunked system’s transmissions, you
must store the trunked system’s frequencies in one of
the banks in your scanner by following these steps.
1. Press
PROG
then
TRUNK
.
TRUNK
appears and
one or more bank numbers flash.
2. Select the bank you want to store the trunked sys-
tem’s frequencies in by pressing a number key.
The scanner automatically selects the first channel
in the bank when you select the bank.
3. Use the number keys to enter one of the trunked
system’s frequencies, then press
E
.
TRUNK,
BANK
and the bank number, the channel number,
and the frequency appear.
Note:
If you entered an invalid frequency, the
scanner beeps, the channel number flashes and
Error
appears. If this happens, press
•
to clear
the frequency, then repeat this step.
4. Press either
PROG
or s to select the next channel
in the bank.
5. Repeat Steps 3 and 4 until all frequencies have
been entered in that bank.
To Next Page
Loading...
