Radio Shack HTX-252 - Connecting the Microphone; Using an External Speaker

12
CONNECTING THE MICROPHONE
1. Align the notch of the
microphone’s plug and
the microphone’s jack,
located on the left side of
the front panel. Then
insert the plug and turn
the metal ring clockwise
to secure the plug.
2. Slide the microphone onto the microphone holder.
To disconnect the microphone from the transceiver, turn the met-
al ring counterclockwise to loosen it.
Caution:
Always disconnect the microphone by grasping its plug.
Never pull on the coiled microphone cable.
USING AN EXTERNAL SPEAKER
To hear your communications better in a noisy environment, you
can plug an optional, external speaker into the transceiver. The
speaker should have an impedance of 8-ohms and be able to
handle 3 to 10 watts of power. The speaker’s cable should have
a
1
/8-inch (3.5-mm) plug.
To connect the speaker, insert the speaker cable’s plug into
EXT.
SP
on the back of the transceiver. This automatically disconnects
the built-in speaker.
M
H
z
F
D
T
M
F
O
N
C
A
L
L
S
T
E
P
S
C
A
N
P
R
I
L
o
c
k
S
H
I
F
T