Radio Shack HTX-252 - A Quick Look at the Display

18
A QUICK LOOK AT THE DISPLAY
1. — appears when
F
key is pressed.
2. — indicates the keypad is locked.
3. — indicates a negative repeater offset.
4. — indicates a positive repeater offset.
5.
SCAN
— appears when the transceiver is scanning frequen-
cies.
6.
PRI
— indicates a priority frequency.
7.
T
— appears when Tone Squelch (CTCSS) is enabled for
transmission only.
8.
T-SQ
— appears when Tone Squelch (CTCSS) is enabled
for both transmission and reception.
9.
Alpha-Numeric Display
— shows frequency and operation
feature information.
10.
TX
— appears when the transceiver is transmitting.
11.
0
to
9
— shows the memory channel in use.
12.
BUSY
— appears when the transceiver receives a signal.
13. — indicates signal strength; the stronger the
signal, the more boxes appear.
14.
ME
— appears when the frequencies and other station data
are being stored or while scanning data in memory loca-
tions.
Note:
When you reset the transceiver, all display elements ap-
pear. See “Resetting the Transceiver” on Page 37.
FUNC