35
TROUBLESHOOTING
If your transceiver is not working as it should and it displays an
error message, these suggestions might help you eliminate the
problem. If the transceiver still does not operate properly, take it
to your local RadioShack store for assistance.
Symptom Possible Cause and Solution
Problems with reception
Squelch setting too high
.
Adjust as needed.
Tuned to a non-operating fre-
quency.
Tune to an active frequency.
Antenna not properly attached.
Check and reconnect if needed.
Poor antenna cable connec-
tions.
Check connections and
repair or replace as needed.
Problems with transmis-
sion
Poor antenna cable connec-
tions.
Check connections and
repair or replace as needed.
Check all connections for corro-
sion and clean if necessary.
PTT button not fully pressed
.
Press firmly and hold down when
transmitting.
Microphone connection loose
.
Secure the connection.
No Power
Check fuse.
Replace if blown.
Check power cables and con-
nections.
Repair or replace if
broken or disconnected.
To Next Page
Loading...
