Radio Shack HTX-252 - Scanning Operation; Scanning Active Frequencies; Scanning Memory Locations

27
SCANNING OPERATION
SCANNING FOR ACTIVE FREQUENCIES
1. To search for activity on a frequency, press
SCAN (PRI)
.
SCAN
appears. The transceiver begins to scan up or down
the full frequency range. The transceiver stops on each
active frequency for 5 seconds if squelch is on. If squelch is
off, the transceiver stops on each location for about 1 sec-
ond.
2. To change the scanning direction, press
UP
or
DN
.
3. To stop on a frequency or to stop scanning completely,
press
SCAN
again.
SCANNING STANDARD MEMORY
LOCATIONS
1. Press
MS (MR)
then
SCAN
. The transceiver scans all mem-
ory locations except empty locations.
2. To change the scanning direction, press
UP
or
DN
.
3. To stop scanning, press
SCAN
again.