26
USING THE CALLING-FREQUENCY
MEMORY
The calling-frequency memory location lets you quickly jump to a
specific programmed frequency at any time. The default calling
frequency is 146.52 MHz. You can store a different frequency into
memory as well as other settings associated with that frequency,
such as the repeater offset and CTCSS tone.
1. Select the desired calling frequency using
UP
/
DN
or the tun-
ing control.
2. Press
F+MR (MS)
. A memory location and
ME
appear.
3. Rotate the tuning control or repeatedly press
UP
or
DN
until
C
appears in the memory location area on the display.
4. Press
MR (MS)
.
C
flashes.
5. Press
MR (MS)
again
to store the selected frequency.
6. Press
VFO (T-SQ)
to return to the VFO mode.
To enable the calling frequency, press
CALL
at any time. The
transceiver immediately tunes to that frequency with the settings
you programmed. To exit the calling frequency mode, press
VFO
(T-SQ)
.
To Next Page
Loading...
