© 2020 Radiodetection Ltd 12
Figure 4.4 Press the retaining latch inwards
4 Rotate the battery pack away and up from the latch
5 Repeat on the other side to release the battery pack
completely then lift the battery pack away
Figure 4.5 Repeat then lift the battery pack away
To fit a new battery, lift both accessory covers slightly,
then gently push the replacement pack into place until it
clicks on both sides, then close the battery pack
Figure 4.6 Installing a new battery pack
If using the Li-ion battery pack, plug the lead into the
battery connector (fig 4.7).
Figure 4.7 Connecting the Li Ion lead
NOTE: Fully charge your lithium-ion battery pack before
its first use
Transmitter battery pack:
1 Unlatch then remove the accessory tray
Figure 4.8 Release then remove the accessory tray
2 Turn the release catch, then open the battery
compartment
3 Release the retaining catch (fig 4.10) by pressing
gently, then lift the battery pack away
4 Line up the battery pack clips with the corresponding
recesses on the transmitter body and press into
place (fig 4.11)
5 Close the battery pack, turn the retaining latch and
replace the accessory tray
To Next Page
Loading...
