RADIOLINK ELETRONIC LIMITED
4. RC6GS Functions
4.1 Display When Power Switch Turned On
LCD Screen
When you power on the transmitter RC6GS, LCD screen shows Model Name, Transmitter Name,
Battery Voltage, Steering Trim, Throttle Trim.
Model Name
The system can store the data for 10 models, model name will show on the LCD when you power on
the transmitter. Please make sure the model name is the right one that you want.
If the model name you chose is not corresponding with your model, the settings should be wrong.
Battery Voltage
In addition to the model, LCD can show the voltage of battery. When the voltage is lower than 4.6V, it
would start the low-voltage alarm, it would send out “ DDD … ” sounds, till the transmitter is
power-off. When you hear the low-voltage alert, you have no more than 4 minutes for controlling
your model, please safely stop your model before the uncontrolled situation. Please make sure the
battery voltage is higher than this voltage data while radio controlling.
Transmitter function menu setting
When you want to browse or change a setting of transmitter, you should go into function menu
setting mode. Under function menu setting mode, you can set up Language. Select "LANGUAGE" ,
Model Select "MODEL", End Point Adjuster "EPA", Steering EXP "STEXP", Steering Speed "STSPD",
Throttle EXP "THEXP", Throttle Speed "THSPD", A.B.S. Function "A.B.S", Throttle Acceleration "ACCEL",
Idle-Up "IDLUP", Sub-trim "SUBTR", Servo Reverse "REV", Steering Dual Rate/Second. Dual Rate "D/R",
ATL Function "ATL", Programmable Mixes "PMIX", Auxiliary, Channel 3, 4, 5 and 6 "AUX"，Model name
"NAME", Reset function "RESET".
4.2 Language Select "LANGUAGE"
Both English and Chinese version menu are available for which is convenient for Chinese and
English-speaking players to personalize function menus.
To Next Page
Loading...
Need help?
General
