RadioLink RC6GS - Programmable Mixes (PMIX); Master and Slave Channel Setup; Mixing Amount Adjustment; Mixing Mode Selection

RADIOLINK ELETRONIC LIMITED
www.radiolink.com
23
Setup Item
RATE: Brake amount
Brake amount (RATE)
0%~100%
Initial value: 100%
(1) Enter the function menu and use “Dec(-)” or “Inc(+)”button
to access ATL function.
(2) Press “Enter” button to get into ATL function interface.
(3) Press “Enter” key, and the initial value of RATE will blink. Use
“Dec(-)”or“Inc(+)” button to adjust the value.
(Note: In the interface of adjusting the value, return to the initial value "100%" by pressing “Dec(-)”
and “Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
(4) When ending setting, return to the initial screen by pressing“Exit” button twice.
4.16 Programmable Mixes "PMIX"
Programmable mixes between arbitrary channels
These functions allow you to apply mixing between the steering, throttle, CH3, CH4, CH5 and CH6.
Setup items
LEFT: Mixing rate (Left side)
RGHT: Mixing rate (Right side)
MST: Master channel
SLV: Slave channel
Programmable Mixes "PMIX"
MXMD:Mix mode
Enter the function menu and use“Dec(-)”or “Inc(+)” button to access PMIX function, then press
“Enter” button to get into PMIX function interface.
(1) Master channel
Channel selection (MST)
ST, TH, CH3, CH4, CH5, CH6
Initial value: ST
Select setup item"MST" by pressing “Dec(-)” or“Inc(+)”button, press“ Enter ” button, the initial
master channel will blink. Use“ Dec(-)”or“ Inc(+) ” button to select the master channel you wish
to adjust, press“Enter” button,the blinking master channel you selected will stop blinking.