RADIOLINK ELETRONIC LIMITED
Aux Servo EPA Aux Servo EPA
CH3:0%~120%(left/ right) CH4:0%~120%(left/ right)
Initial value: 100% Initial value: 100%
Aux Servo EPA Aux Servo EPA
CH5:0%~120%(left/ right) CH6:0%~120%(left/ right)
Initial value: 100% Initial value: 100%
(1) Access the function menu (By pressing “Exit” and “Enter” buttons simultaneously and holding
them down for one second),press “Inc(+)” button twice to chose EAP function.
(2) Press “Enter” button to get into EPA function interface, use “Dec(-)” or “Inc(+)” button to
select the desired setting item , press “Enter” key, the initial value of your selected setting item will
blink, then you can press “Dec(-)” or “Inc(+)” button to adjust the value of your selected setting
item.
(Note: In the interface of adjusting the value, return to the initial value "100%" by pressing “Dec(-)”
and “Inc(+)” buttons simultaneously for about 1 second.)
3. Press “Enter” button, the adjusted value of your selected setting item stops blinking, now the
value of your selected setting item has been set.
4. Return to the initial screen by pressing “Exit” button twice.
4.5 Steering EXP "STEXP"
This function is used to change the sensitivity of the steering servo around the neutral and both ends
position. It has no effect on the maximum servo travel.
Adjust the sensitivity of direction wheel both in neutral position and ends.
0%~-100%: Sensitivity around neutral position is low,
getting higher when approaching ends.
0%: Sensitivity around the neutral and ends position is equal
0%~+100%: Sensitivity around neutral position is high, getting lower when approaching ends
Steering operation curve adjustment
(1) Access the function menu (By pressing “Exit” and “Enter ”buttons simultaneously and holding
them down for one second ), press “Inc(+)” button three times to chose EAP function.
(2) Press “Enter” button to get into STEXP function interface, press “Enter”key and the initial value
To Next Page
Loading...
