RADIOLINK ELETRONIC LIMITED
3.2.1 Receiver Installation and Binding
How to Match Code With Transmitter:
1. Put the transmitter and the receiver close to each other within 50 centimeters.
2. Turn on the transmitter, then power on the R6FG.
3. There is a black button on the R6FG, press the binding button twice in two seconds and release,
receiver light start blinking, after about blinking 8 times, match code success then receiver signal LED
always on!
Attention: R6FG default have not turn on the gyro function. Make sure the R6FG keep motionless
when power on it, because the R6FG will do the self-test.
R6FG with two indicate LED, green LED on indicate normal working mode while both green and red
LED on indicate gyro function working mode.
3.2.2 Working Mode
R6FG has two working modes：normal working mode and gyro function working mode.
Green LED, gyro will not working.
Gyro Function Working Mode
Both green and red LED on.
Receiver with gyro integrated to hold the vehicle in a straight line during aggressive acceleration and
braking or get bumped around by rough terrain.
Receiver with gyro integrated to keep the uni-direction and anti-slip.
3.2.3 How to Turn On Gyro Function
Quick press the ID SET switch two times within 1 second, the LED change from green to red means
gyro function has turn on.
Integrated Gyro, is used to assure the stability of cars on turning status; and keep on straight running
even the cars get some mechanical phantom. Gyro function can be enabled or disabled.
Gyro preset disabled, and it enters post indication status. There are two indicators on the receiver. The
green one shows the receiver status and the red one is for gyro. When the led turns on, the gyro is
enabled , and the led turns off, gyro disabled.
Cars can be drove forward and backward, gyro is enabled forward or backward correspondingly. Like
the EP cars, different connection will make different direction, the gyro is ensured to be enable
Same like a plane has reverse, car kit gyro has reverse as well. Only right set reverse gyro can act to
To Next Page
Loading...
Need help?
General
