RADIOLINK ELETRONIC LIMITED
4.18 Model Name "NAME"
RC6GS stores model memories for ten models. Each model memory can be named separately
according to user’s requirement.
Factory default name: MODEL1
(1) Enter the function menu and use “Dec(-)” or “Inc(+)”
button to access NAME function.
(2) Press “Enter” button to get into NAME function interface,
the first character of current name will blink, and the blinking
character can be reset. The common use characters appear at
the bottom of the screen, use “Dec(-)” or “Inc(+)” button to
choose the character you desired.Press“Enter” button again,
the next character of current name will blink. Reset other
characters of current name in same manner.
(3) After accomplishment of naming, all characters of current name will stop blinking, the new name
will be stored automatically.
(4) When ending setting,return to the initial screen by pressing“Exit”button twice.(the new setting
model name will appear on the initial screen)
4.19 Low Voltage Alarm
The transmitter’s low voltage alarm adjustable, it depends on what kind of battery, the 4.6V is may
cause the battery over discharge and damage the battery. So
you can set transmitter’s warning voltage when you use
There are four options you can choose:
ALARM: adjustable 4.0V to 16.0V
The car will be out of control if the battery runs out, please
immediately stop running when the alarm starting to ring.
This function is available to set gyro sensitivity and VR mixing ON
When MIX set OFF, gyro is disabled while when MIX set ON, you
can adjust gyro sensitivity STD or VR. STD is adjusted on screen
In normal mode (STD), range of sensitivity is 0%-100%.
(1) Enter the menu, use Dec(-) and Inc(+) to select options for
(2) Press the key button “Enter” to enter sub-menu gyro
To Next Page
Loading...
Need help?
General
