RADIOLINK ELETRONIC LIMITED
sensitivity.
(3) Press “Enter” again, the initial value will start flashing, then use Dec (-) and Inc (+) to change the
value.
(4) Press the button key “Enter”, the value stops flashing, the setting is finished now.
(5) "Mode"and "Rate" can also be set by the same step.
(6) Press button key “Exit” to be back to initial screen.
4.21 Fail Safe
This function is set by servo, throttle, CH3, CH4, CH5 and CH6.
Option:
ST: Steering(CH1)
TH: Throttle(CH2)
CH5: -100~+100
CH6: -100~+100
Initial value: 0
(1) Enter the menu, use “Dec (-)” and “Inc (+)” to select options to set.
(2) Press the button key “Enter” to enter menu.
(3) Use “Dec (-)” and “Inc (+)” to select SERVO, then press “Enter”. Now the initial value
of SERVO will start flashing, use handle to change the value.
(4) Press the button key “Enter”, the value stops flashing, now the value of SERVO is set.
(5) THROTTLE is to set by the trigger.
CH3 is to set by VR controller.
CH4 is to set by the button switch.
CH5 is to set by the toggle switch.
CH6 is to set by the toggle switch.
(6) Press “Exit” two times to back to initial screen.
4.22 Reset Function "RESET"
RESET- Data reset function:
All the data for any model memory can be reset to original factory defaults. Often this function is
To Next Page
Loading...
Need help?
General
