RADIOLINK ELETRONIC LIMITED
Initial value: 0%
(2) Brake side acceleration amount adjustment
Press “Dec(-)” or “Inc(+)” button to select “ BRAK ”, press“Enter”key to confirm and
the initial value of “BRAK” will blink, then use“Dec(-)”or“Inc(+)”button adjust the acceleration
amount.
(Note: In the interface of adjusting the value, return to the initial value"0%" by pressing
“Dec(-)” and “Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
"0%": No acceleration
"100%": Maximum acceleration (Brake side maximum steering angle)
Brake side acceleration amount(BRAK)
0%~100%
Initial value: 0%
When ending setting, return to the initial screen by pressing “Exit” button twice.
4.11 Idle-Up "IDLUP"
Idle up at engine start
Use this function to improve the starting characteristics of the engine by raising the idling speed
when starting the engine of a gas powered car.
-50% ~ -1%, 0%, +1% ~ +50%
(1) Enter the function menu and use “Dec(-)” or“Inc(+) ”
button to access IDLUP function.
(2) Press “Enter” button to get into IDLUP function interface.
(3) Press “Enter” key, and the initial value of RATE will blink. Use“ Dec(-) ” or “Inc(+)” button
to adjust the value.
(Note: In the interface of adjusting the value, return to the initial value "0%" by pressing “Dec(-)” and
“Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter”button, the adjusted value stops blinking, now the value has been set.
(4) When ending setting, return to the initial screen by pressing “Exit”button twice.
4.12 Sub-trim "SUBTR"
Servo center position adjustment
Use this function to adjust the neutral position of the steering, throttle and channel 3 servos.
To Next Page
Loading...
Need help?
General
