RadioLink RC6GS User Manual

RADIOLINK ELETRONIC LIMITED
www.radiolink.com
24
(2) Slave channel
Channel selection (SLV)
ST, TH, CH3, CH4, CH5, CH6
Initial value: ST
Select setup item "SLV" by pressing “Dec(-)” or “Inc(+)” button, press “Enter” button, the initial
slave channel will blink. Use“Dec(-)”or“Inc(+)”button to select the slave channel you wish to adjust,
press “Enter” button, the blinking slave channel you selected will stop blinking.
(3) Left, forward or up side mixing amount adjustment
Mixing amount
-100~0~+100
Select the setting item "LEFT", "FWRD", or "UP"(These setup items are different depend on the master
channel. ST: "LEFT"; TH: "FWRD"; CH3:"UP") by pressing “Dec(-)” or “Inc(+)” button. Press “Enter”
key, the initial value of "LEFT", "FWRD", or "UP" will blink, Use“Dec(-)”or“Inc(+)”button to adjust
the left, forward, or up side mixing amount.
(Note: In the interface of adjusting the value, return to the initial value "0" by pressing“Dec(-)”and
“Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter” key, the adjusted value stops blinking, the selected mixing amount has been adjusted.
(4) Right, brake or down side mixing amount adjustment
Mixing amount
-100~0~+100
Select the setting item "RGHT", "BRAK", or "DOWN"(These setup items are different depend on the
master channel.ST:"RGHT"; TH:"BRAK";CH3:"DOWN") by pressing“Dec(-)”or“Inc(+)”button. Press
“Enter”key,the initial value of "RGHT", "BRAK", or "DOWN" will blink, Use“Dec(-)”or“Inc(+)”button
to adjust the right, brake, or down side mixing amount.
(Note: In the interface of adjusting the value, return to the initial value "0" by pressing “Dec(-)” and
“Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter” key, the adjusted value stops blinking, the selected mixing amount has been adjusted.
(5) Mixing mode setup
Mixing mode (MXMD)
OFF, MIX
Initial value: OFF
Select setup item"MXMD"by pressing“Dec(-)”or “Inc(+)” button, press “Enter “ button, the initial
mixing mode“OFF”will blink. Press“Dec(-)”or “Inc(+)”button to switch “OFF” to “MIX”, press
“Enter” button, the blinking “MIX” will stop blinking.
"OFF": Mixing proportional to master channel operation.
"MIX": Mixing by master channel another function considered.

RadioLink RC6GS Specifications

General

Channels	6
Frequency	2.4GHz
Model Memory	10 models
Telemetry	Yes
Spread Spectrum	FHSS
Channel Bandwidth	400KHz
Modulation Mode	GFSK
Low Voltage Alert	Yes
Antenna Length	106mm
Display	LCD
Range	600 meters
Power Supply	2S LiPo
Compatibility	R8EF, R8FM, R8F receivers
Model Type	Car, Boat
Operating Voltage	4.8 - 15V DC
Screen	128x64 LCD
Max Range	600m
Receiver	R7FG