13
(3) T8S will make DD sounds, press any of the trimmer buttons to stop the D sounds.
READ: Click READ, two short D sounds will be heard and the APP starts reading the data in
T8S. Every time the APP is reopened, the data displayed is the initial default value. If the
parameters are modified, you need to click to
“
READ
”
again to display the modified data.
WRITE: Click “WRITE” and three slow D sounds mean the modified data have been written
successfully. If no D sound means update failure, please reconnect T8S to the APP and re-write.
Click “WRITE” each time parameter is modified to make sure it’s well input to the T8S.
* After modifying the parameters, please click to write data, otherwise the modification will be
invalid.
* If you want to restore the factory default settings, you can click "Factory Settings".
LOAD: Click LOAD and a pop out of ‘Model Select’ will display. If there is no successfully
stored data, there will be no display. Besides, user also can create a new file or select among the
saved files.
SAVE: Click to save the APP data as a file in the computer.
Note: Each interface can display the transmitter voltage, receiver voltage, RSSI value, and
telemetry battery voltage (Telemetry function is available when using R8FG, R7FG, R8F, R8XM
receivers ).
To Next Page
Loading...
Need help?
General
