21
The interface of parameter setup software on computer.
3.3.2 ATTITUDE
Select the preferred channel from CH5 through CH8. CH5 is always the default switch to
change attitude when connect to flight controller PIXHAWK/MINI PIX/crossflight/APM/TURBO
PIX with multi-rotor firmware, and CH8 is the default switch with fixed-wing firmware, while CH7 is
default when connect to DJI flight controller. For the default channel to switch attitudes, please
refer to the flight controller user manual.
Note: After open the “Attitude” function, the switch of CH5 and CH7 will be used by default
to control the output of the “attitude channel”.
The values behind each channel means different control percentage output different control
signals. The default values of T8S of each attitude is corresponding to the values of flight
controller PIXHAWK/MINI PIX/crossflight/APM/TURBO PIX. That is, when the above flight
controllers are used with T8S, attitude can be selected on the Mission Planner and no need to
setup specific parameter.
Different values can be set for ATTI 1 to ATTI 6. Then you can change the flight attitude by
press CH5/CH7.
To Next Page
Loading...
Need help?
General
