28
The interface of parameter setup software on computer.
3.4.4.2 ALARM
TX-ALARM
The default low voltage value of transmitter is 3.7V for T8S and the alarm value cannot be
modified. When the transmitter voltage is lower than 3.7V, T8S will continuously make “D ”
sounds to warn.
RX-ALARM
The default low voltage value of receiver is automatically set 4V by default, and small
adjustments are also supported. When the compatible receiver supports receiver voltage
telemetry and the receiver voltage is lower than the value set, T8S will make “DDDDD” sounds
as a unit to warn. (Note: R8EF receiver does not support receiver voltage telemetry)
EXT-ALARM
To return the model voltage, RadioLink receivers of telemetry functions such as R8XM, R8FG,
R7FG or R8F should be used. small adjustments are also supported. When the model voltage goes
lower than the set value, T8S will make “DDD” sounds as a unit to warn. We suggest that 7.4V set
for 2S lithium battery, 11.1V set for 3S lithium battery, 14.8V set for 4S lithium battery.
RSSI-ALARM
The default signal strength alarm value of the T8S is -100dBm. You can set a reasonable value
according to the actual situation to prevent the model from losing control due to weak signal.
When the RSSI goes lower than value you set, T8S will make ”DDDD” sounds as a unit to warn.
To Next Page
Loading...
