Running analyses 63
4. Running analyses
* IMPORTANT *
Before pressing the Run key, check the following points listed below:
1. Select the method by pressing 2 in the Main window.
2. If Question marks "?" are present in the electrode and/or
reagent tabs. Programming error due to missing electrode/reagent
parameters. Contact your supervisor.
3. Connect/Check electrode(s). Refer to Short-Form Reminder no. 1.
When installing/checking an electrode system, do not forget to
connect all the electrodes to the Titration Manager and disconnect
all the electrodes that are not used by the method.
4. Install/Check reagent(s). Refer to Short-Form Reminder no. 2.
5. Run the analysis when Sunny icons are visible in the electrode and
reagent tabs.
6. Run an electrode calibration when a Stormy icon appears in the
electrode tab.
7. Run a reagent calibration when a Stormy icon appears in the
titrant tab.
8. If you are unable to display the "Run" command due to the presence
of Cloudy/Stormy icons in the Reagent and Electrode windows,
activate the "Check" command. The Titration Manager will
automatically guide you through the necessary operations required
to solve the problem(s).
To Next Page
Loading...
